DIY Rotatable Position IKEA Monitor Stand

Sep 18th
White IKEA Monitor Stand
White IKEA Monitor Stand

DIY Rotatable Position IKEA Monitor Stand – Swivel position serves as a platform for a monitor, TV, or other items, but can be rotated easily. The hardware makes it possible for this movement is a lazy Susan bearing. Building a simple swivel monitor stand is not a complicated project. Instructions to build rotatable position IKEA monitor stand. While set two 26-inch boards on edge, parallel, and 23 inches apart. Set the 23-inch boards between them at right angles to the edge, parallel, 23 inches apart so the corners of the four boards together and rinse. The outside dimensions of these four boards are 26-by-26-inches. Set a sheet of plywood on top of the boards so the edges of the plywood is flush with the boards

Next steps to build rotatable position IKEA monitor stand, using 3-inch screws. Screw sixteen screws through the plywood so four screws in each board. Later on turn the plywood and boards as board rests on top of the plywood. Enter a 29-inch board perpendicularly inside each corner and screw four three-inch screws through each corner to secure the boards. And also 29-inch boards are legs to the monitor stand. Activate stand upright and enter Lazy Susan berries on top of the plywood.

12 Picture Gallery: DIY Rotatable Position IKEA Monitor Stand

Next steps to build rotatable position IKEA monitor stand, the layer should be 10 inches from each edge of the plywood. Draw a circle through any holes in the plywood to keep the warehouse in the measured position. Move layer of plywood and drill the 1/8-inch holes through each of the circles drawn. With a piece of plywood that is not linked to the stand set the layer so it is 10 inches from each edge of the plywood. Screw the bearing to the plywood with 1/2-inch screws. Position the bearing and plywood over the holes drilled on the stand. Align the holes in the layer with the holes in the plywood booth section. Inserting a bolt through the bottom of the frame and into the threads of the layer, using the hardware provided. The top of the plywood should now be able to rotate 360 degrees.

This post topic: IKEA IDEAS

Other Interesting Things About IKEA IDEAS Photos